Free Arm Bottom Cover; Bottom Plate (Base); Front Panel - ELNA xquisit Service Manual

Elna International Corps. SA Xquist

FREE ARM BOTTOM COVER

1. Loose the screws 1 and 2.
2. Remove the bottom cover

BOTTOM PLATE (BASE)

To facilitate the disassembling of the front and
rear panel, please loose the 5 screws from the
base.
1. Loose the screws 1 through 5.
2. Remove the base
1. Remove screws 1 and remove the needle plate
2. Remove the screw 2 and loose the screw 3
3. Insert a thin screwdriver into section C and
remove the claw.
4. Applying force to section A in the direction ->
inserts a thin screwdriver into section D and
removes the claw.
5. Remove section E at the jaw section while
lowering the rear panel.
6. Make sure that the small pin F inside of the
front panel in G is lowered before open the
claw H.
7. Remove all connectors see drawing below.
service manual

FRONT PANEL