Ip Igmp Ignore-V2-Messages - Avaya Secure Router 3120 Command Reference Manual

MULTICAST COMMANDS
example:
In the following example, no ip igmp ignore-v1-messages is used to enable processing of
IGMPv1 messages on interface ethernet 1/1.
SR/configure/ip/igmp/interface ethernet 1/1> no ignore-v1-messages
applies to:
All modules

ip igmp ignore-v2-messages

Controls the processing of all IGMPv2 messages on the associated interface. Note that this
breaks interoperability with older IGMPv2 users on the network and should be done when it is
important to maintain small group leave latencies. (This command is only effective for IGMPv3.)
Use the no form of this command to allow IGMPv2 messages on the specified interface. This
command is disabled by default.
syntax:
[no] ip igmp ignore-v2-messages
example:
In the following example, ip igmp ignore-v2-messages is used to disable processing of IGMPv2
messages on interface ethernet 1/1.
SR/configure/ip/igmp/interface ethernet 1/1> ignore-v2-messages SR/configure/ip/igmp/
interface ethernet 1/1>
applies to:
All modules
ip igmp last-member-query-count
Configures the Last Member Query Count per RFC 3376. It specifies the count for querying
the last member of the group. The default is: robustness value. Use the no form of the
configuration to return to the default lastmember-query-count value.
Note:
Specifying a value in the no form has no effect on the configuration
syntax:
752 Avaya Secure Router 3120 Command Reference Guide December 2010