Black & Decker JT2504BD Instruction Manual page 39

Problem Possible Cause
• Material • Rip fence out of adjustment.
• Riving knife not aligned with
kicked back
from blade.
• Feeding stock without rip fence.
• Riving knife not in place.
• Dull blade.
• The operator letting go of
• Miter angle lock knob is not
• Blade does • Sawdust and dirt in elevation/
not raise or tilt
freely.
• Blade does • Extension cord too light or too
not come up to
speed. Reset • Low house voltage.
trips too easily.
• Machine • Saw not mounted securely to
vibrates
• Bench on uneven floor.
excessively.
• Damaged saw blade.
• Does not • Miter gauge out of adjustment.
make accurate
45° and 90°
crosscuts.
For assistance with your product, visit our website www.blackanddecker.com for the
location of the service center nearest you or call the BLACK+DECKER help line at
1-844-437-5095.
BLACK+DECKER and the BLACK+DECKER logo are registered trademarks of
BLACK+DECKER and are used under license. All rights reserved.
TROUBLESHOOTING
blade.
material before it is past saw
blade.
tight.
tilting mechanisms.
long.
workbench.
Power Tool Specialists, Inc.
Rock Hill, SC 29730 U.S.A.
Possible Solution
• Align rip fence with miter gauge
• Align riving knife with blade.
• Install and use rip fence.
• Install and use riving knife. (with
• Replace blade.
• Push material all the way past
• Tighten knob.
• Brush or blow out loose dust
• Replace with adequate size
• Contact your electric company.
• Tighten all mounting hardware.
• Reposition on flat level surface.
• Replace blade.
• Adjust miter gauge.
Imported by
684 Huey Road
39
slot.
guard)
saw blade before releasing
work.
and dirt.
cord.
TM