Operating Instruction - Black & Decker JT2504BD Instruction Manual

NOTE:
• This table saw is provided with a 10 in.
diameter blade with a body thickness of
0.07 in. thick with a kerf of 0.10 in. The
riving knife is 0.09 in. thick. The blade
diameter and the blade body and kerf
dimensions must be properly matched
with the riving knife thickness.
• The maximum radial distance between
the riving knife and the toothed rim of
the saw blade is 0.12 in ~ 0.31 in.
• The tip of the riving knife shall not be
lower than 0.04 in. ~ 0.2 in. from the
tooth peak.
• The riving knife is thinner than the width
of the kerf by approximately 1/64 in. on
each side.
• The blade body must be thinner than
the thickness of the riving knife but the
blade kerf must be thicker than the
riving knife.
ADJUSTING EXTENSION TABLE
LOCKING LEVERS (FIGURE JJ)
If the extension table moves when it is
open and locked, then the extension table
locking levers (1) may be loose and need
adjustment. To adjust the tension of the
locking lever, turn the nut (2) with a 8 mm
wrench until it is tightened, but do not over
tighten.
JJ
2
Under Table View
1
27

OPERATING INSTRUCTION

RAISING THE BLADE (FIGURE KK)
To raise or lower the blade, turn the blade
elevation/tilting handwheel (1) to the
desired blade height.
KK
1
TILTING THE BLADE (FIGURE KK)
Loosen the blade lock knob (2), move the
handwheel (1) to the desired angle, then
tighten the blade lock knob (2).
ON/OFF SWITCH (FIGURE LL)
The ON/OFF switch has a safety key (1).
With the key removed from the switch,
unauthorized and hazardous use by
children and others is minimized.
• To turn the saw ON, insert the safety
key (1) into the slot in the switch (2).
Move the switch upward to the ON
position.
• To turn the saw OFF, press the switch
downward.
• To lock the switch in the OFF position,
grasp the yellow part of the switch (1),
and pull it out.
• With the safety key removed, the switch
will not operate.
• If the safety key is removed while
the saw is running, it can be turned
OFF but cannot be restarted without
inserting the safety key (1).
WARNING
! ALWAYS lock the switch
"OFF" when the saw is not in use.
Remove the safety key and keep it in
a safe place. In the event of a power
failure, blown fuse, or tripped circuit
breaker, turn the switch "OFF" and
remove the safety key, preventing an
accidental startup when power comes
on.
2