Push Block - Black & Decker JT2504BD Instruction Manual

RR
3
5
4
AUXILIARY FENCE (FIGURE SS)
Making the base:
• Start with a piece of 3/8 in. plywood at
least 5-1/2 in. wide or wider and 21 in.
long or longer.
• Cut the piece to shape and size shown.
Making the side:
• Start with a piece of 3/4 in. hardwood at
least 1-3/4 in. wide or wider and 21 in.
long or longer.
• Cut the piece to shape and size shown.
Putting it together:
• Fasten the pieces together with glue
and woodscrews.
WARNING
Make sure the screw
!
heads do not stick out from the bottom
of the base; they must be flush or
recessed. The bottom must be flat and
smooth enough to rest on the saw table
without rocking.
SS
3/8 in. thick plywood base
The edge must be
parallel with the face
1
2
21 in.

PUSH BLOCK

Use for ripping operation when the
workpiece is too narrow to use a push
stick. Always use a push block for rip
widths less than 2 inches.
MAKE A PUSH BLOCK (FIGURE TT)
Making the base:
• Start with 3/8 in. plywood at least
5-1/2 in. wide or wider and 12 in. long
or longer.
• Cut the piece to shape and size
as shown.
Making the handle:
• Start with 3/4 in. hardwood at least 5 in.
wide or wider and 7 in. long or longer.
• Cut the piece to shape and size
as shown.
Making the bracket:
• Start with 3/8 in. wood at least 3/8 in.
wide or wider and 2-1/2 in. long or
longer.
• Cut the piece to shape and size
as shown.
Putting it together:
• Fasten the base and handle together
with glue and woodscrews.
WARNING
!
heads do not stick out from the bottom
of the base, they must be flush or
recessed.
• Fasten the base and bracket together
with glue.
WARNING
!
use the screws to fasten the base and
bracket.
TT
3/8 in.
5-1/2 in.
31
Make sure the screw
To avoid injury, do not
3/8 in.
5 in.