Table of Contents
Advertisement
J
2
INSTALLING THE HANDWHEEL
HANDLE (FIGURE K)
NOTE: UP-DOWN is printed on this
handwheel.
• Thread the handwheel handle (1) into
the handwheel hole (2) and tighten.
K
INSTALLING THE REAR SUPPORT
(FIGURE L, M)
• Insert the two rear support tubes (1)
into the rear support (2). (Figure L)
NOTE: They must be inserted into the
back of the rear support with the dimple
end so that the bar will hold the rear
support in place.
• Snap two plastic stops (3) over the two
rear support tubes (1). Make sure the
locating pin in the plastic stops fits into
the matching hole in the support tube.
This will "lock" the tube into the support.
(Figure L)
NOTE: The plastic stops (3) must be
installed underneath the rear support
tubes (1).
2
L
1
• Insert the rear support tubes (1) into the
two holes in the rear of the saw table,
and into the support tube brackets
under the table. Position the rear
support assembly as the instruction
labels are facing up. (Figure M)
• Tighten one rear support stop screw (4)
on the one of the end of the rear
support tubes (1) using a philips head
1
screwdriver. Verify that the screw is
fully inserted into the corresponding
hole in the support tube. (Figure M)
M
18
dimple end
2
3
4
1
1
Advertisement
Table of Contents
