Reassembly Process
Replacing the LCD Module
1. Tilt the LCD hinge approximately at a 45° angle then insert the upper case and align the
screw posts of the upper case with the screw holes in the LCD hinges.
2. Verify that the LCD cable is looped properly in the LCD hinge as shown.
+
IMPORTANT:
Machine Maintenance
Downloaded from
www.Manualslib.com
Figure 3-66. Upper Case
Figure 3-67. Upper Case
Make sure that the LCD cable is not entangled with the upper case and take
extra care not to scratch the LCD cable.
manuals search engine
0
0
3-43