Hitachi C47-WD8000 Service Manual page 22

TROUBLE SHOOTING
How to Adjust 9 Point Manual Convergence
Adjustment Preparation
Receive RF or Video signal.
Adjustment Procedure
Press and hold the MAGIC/MANUAL FOCUS button for more than 3 seconds to enter the MANUAL CONVERGENCE
mode.
Press and hold the MAGIC
FOCUS button more than
3 seconds.
(Note: If you press the MANUAL FOCUS button on the side panel of C43-FL8000 model, the TV will enter the MANUAL
CONVERGENCE mode directly.)
(1) Press the ▲ ▼ ◄ ► cursor buttons to move the selection box to select the adjustment point. Press the ENTER
button to change the color of the selection box to red. Press the ▲ ▼ ◄ ► cursor buttons to adjust red convergence.
Note: Press the number buttons (2, 5, 4, 6) can also move the selection box to select the adjustment point, and then to
adjust red convergence directly.
(2) Press the ENTER button to change the selection box to blue. Press the ▲ ▼ ◄ ► cursor buttons to adjust blue
convergence.
(3) Press the ENTER button to change the selection box to white. Press the ▲ ▼ ◄ ► cursor buttons to move the
selection box to select another adjustment point, then perform (1)~(2) to adjust.
Notes: 1. During the adjustment, press the ENTER button frequently to return to the moving mode (
which means the selection box is in the moving mode.) and affirm convergence of the selection box so as to get
the best convergence.
2. If you cannot insure perfect alignment, please try to get balance in alignment between
(4) When adjustment is done, press the MENU button and the following screen will display as below. Press the number
keys to perform the following procedure.
[0]: To cancel the adjusted data and exit from adjustment mode.
[1]: To save the adjusted data and exit from adjustment mode.
[2]: To return to manual convergence mode.
[3]: To recall the adjusted data from previous auto convergence
and return to manual convergence mode.
Notes:
1) During the adjustment, you are suggested to adjust again and again, and confirm
the alignment of the selection box in the moving mode.
2) If there is no operation for 3 minutes from the remote control unit, the TV will exit from MANUAL CONVERGENCE
mode.
MANUAL FOCUS
22
Release the MAGIC
FOCUS button.
PLEASE
ENTER NUMBER
CANCEL ：[ 0 ]
DONE
BACK
RESET
is shown in white,
and .
：[ 1 ]
：[ 2 ]
：[ 3 ]