HP Pavilion 15-bc200 Maintenance And Service Manual page 65

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the base enclosure (see
components:
a. Display assembly (see
b. Hard drive (see
c. SSD (see SSD (M.2) on page
d. Memory (see
e. WLAN module (see
f. Battery (see Battery on page
g. USB (see USB board on page
h. Power button board (see
i. Fan (see Fan on page
j. Heat sink for discrete graphics (see
k. Heat sink for CPU and graphics (see
l. System board (see
m. RTC battery (see
Remove the power connector:
▲ Disconnect the connector cable, and then remove the power connector.
Reverse this procedure to install the power connector.
Base enclosure on page
Display assembly on page
Hard drive on page 31).
33).
Memory on page 34).
WLAN module on page
39).
42).
Power button board on page
45).
Heat sink for discrete graphics memory on page
Heat sink for CPU and graphics on page
System board on page
RTC battery on page 55).
27), and then remove the following
29).
37).
43).
53).
Component replacement procedures
46).
48).
57