Hunter 47905 Owner's Manual page 40

1. Select [ system] in the message window and press
2. System Type: Allows you to select the type of system you have. Conventional
systems typically use a compressor outside for cooling and a separate heating
system inside, where as a heat pumps use the compressor outside for both heat and
cool. If you are unsure of your system type, see "Technical Support" on page 52.
Press either [conventl] or [heat pump] on the screen and choose
to the next option.
3. Furnace Type: If you selected [conventl] on the previous screen, you will need to
specify the type of furnace your system uses. Press either [gas/oil] or [electric] and
choose
Next
Note: If you have a heat pump this setting should be [electric].
4. Span 1: The next menu option is to set your thermostats primary span. The span
setting allows you to adjust the system ON/OFF cycle rate. The default setting is
1F. The system cycles ON or OFF when the temperature is within 2°F (1°C) above
and below the set temperature. The span setting can be adjusted if your system is
cycling too fast or too slowly. Use the
3. Press
Next
Note: Setting a higher SPAN number increases your cycle time by allowing the system
to run longer; a lower number will decrease your cycle time by causing the system to
run for a shorter length of time.
40
to advance to the next option.
to advance to the next option.
Menu Options
or buttons to adjust between 1, 2, or,
44119-01 • 10/10/2012
to enter the system menu.
Next
Next
to advance