Lexmark OptraImage 232 Setup Manual page 25

European Community
(EC) Declaration of
Warning!
This is a Class A product.
In a domestic environment, this product
may cause radio interference, in which
case the user may be required to take
adequate measures
compatibility notices
OptraImage Setup Guide
Conformity
Network
The Ringer Equivalence Number (REN) of this device is 0.06.
The Ringer Equivalence Number (REN) assigned to each terminal
device provides an indication of the maximum number of terminals
allowed to be connected to a telephone interface. The termination of an
interface may consist of any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence Numbers of all the
devices does not exceed 5.
This equipment uses the following USOC Jacks: RJ--11C.
This product is in conformity with the protection requirements of EC
Council directives 98/13/EC, 89/336/EEC, and 73/23/EEC on the
approximation and harmonization of the laws of the Member States
relating to electromagnetic compatibility and safety of electrical
equipment designed for use within certain voltage limits.
A declaration of conformity with the requirements of the Directive has
been signed by Mr. Michel Berdou, Lexmark International Technology,
S.A., Managing Director, Geneva, Switzerland.
This product satisfies the Class A limits of the EMC standard EN 55022
and the safety requirements of EN 60950. It is compliant with the
telecommunication standard: Common Technical Regulation (CTR) 21
and has been granted a Pan-European Telecommunication Terminal
Equipment connection License Number BABT/99/6880.
This notice contains national requirements for proper operation of
telecommunications equipment within specific countries and is based on
the ETSI Document, A guide to the application of TBR 21, EG 201 121
V1.1.2 (1998-07). It applies to all MarkNet print servers which bear the
following mark:
The MarkNet print server has been approved in accordance with
Council Decision 98/482/EC for pan-European single terminal
connection to the public switched telephone network (PSTN). However,
due to differences between the individual PSTNs provided in different
countries, the approval does not, of itself, give an unconditional
assurance of successful operation on every PSTN network termination
point.
In the event of problems, you should contact your equipment supplier in
the first instance.
23