Use Form Feed With Or Without Cutting; Variquest ® Perfecta™ 3600Stp User's Guide - Variquest Perfecta 3600STP User Manual

Change Cutter Settings

Use Form Feed With or Without Cutting

Use Form Feed With or Without Cutting
There are at least two reasons why you might want to advance the form feed with
or without cutting:
To advance form feed:
1. Swipe down the dashboard and from the front panel, touch
CAUTION! CAUTION!
Remove the cut piece from the output platen. If strips or short prints are left on the
output platen, the printer could jam. Check also that there are no pieces of paper
in the cutter guide.
2. To advance the paper without cutting it, swipe down on the dashboard, touch
3-16
• To trim the leading edge of the paper if it is damaged or not straight.
• To feed and cut the paper when the automatic cutter has been disabled.
of the following:
- Touch Form feed. The printer advances.
- Touch Form feed and cut. The printer advances the paper and makes a
straight cut across the front edge.
Note: The printhead is serviced after each print, and the paper cannot be cut
until the process completes, so you may notice a delay.
Note: Photo and coated paper requires careful handling, see "Troubleshooting
Paper or Paper Quality Issues" on page 6-6.
, then touch Form Feed.
®
Perfecta™ 3600STP User's Guide
VariQuest
. Choose one