Wi-Fi Protected Setup (Wps) Setup - Pantum P3010 SERIES User Manual

Note： • If you do not know the network safe mode and password, please
consult your network administrator or access point (wireless router)
manufacturer.
• At present, the printer supports 3 types of safe modes:none, WEP
and WPA/WPA2.
1) None: There is no encryption method used.
2) WEP: Send and receive data via security key by using WEP (Wired
Equivalent Privacy). WEP key is applicable to 64-digit and 128-digit
encrypted network and can contain numbers and letters at the same time.
3) WPA/WPA2: it is the pre-shared key (PSK) of Wi-Fi protected access
which connects wireless device and access point via TKIP or AES
encryption (WPS-Personal). The working length of WPA/WPA2 is within
the PSK of 8-63 characters.
• The Show Password is not ticked by default; if it is ticked, all passwords
input can be seen in clear text.
5. The printer starts to establish wireless connection to access point (wireless router).
6. Click "Done" after successful connection.
Note： • If the printer cannot be used normally after wireless network setup is
finished, please install the drive again. Please select "Wireless
connection (W)" as the installation method (please refer to Chapter
3.1.3 for Windows system and

5.1.2.Wi-Fi Protected Setup (WPS) setup

If the access point (wireless router) supports Wi-Fi Protected Setup (WPS), the Wi-Fi
key on the control panel of printer and WPS key on access point (wireless router)
can be pressed in order to connect the printer to wireless network.
5.1.2.1.Preliminary preparations
1. The access point (wireless router) supports Wi-Fi Protected Setup (WPS).
2. A printer that has wireless network function.
5.1.2.2.Wi-Fi Protected Setup (WPS) method
1. Turn on the power of printer and access point (wireless router).
2. Make sure the printer is in ready state.
Note： • If the printer is in sleep mode, it can be woken up by pressing any
key on the control panel of printer.
3. Press the "Wi-Fi key" on the control panel of printer for more than 2s until the blue Wi-Fi
indicator of printer blinks, and then release pressing.
4. Press the WPS key on access point (wireless router) within 2min and then release it.
Chapter 3.3.3 for Mac system).
32