Wired Network Setup (Applicable To Wired Network Models); Set Ip Address; Automatic Setting; Manual Setting - Pantum P3010 SERIES User Manual

4.Wired network setup (applicable to wired
network models)
In case printers support wired network printing, they can be connected to
network to control printer to print in wired network mode.

4.1.Set IP Address

The IP address of the printer may be automatically obtained through DHCP function or set
manually.

4.1.1.Automatic Setting

DHCP automatic setting function is enabled by default on the printer.
1. Connect the printer to the network through a network cable and complete
the startup preparation work.
2. The printer will receive the IP address assigned by server automatically.
It may take server minutes to receive IP address under the influence of
network environment.
You can check the IP address of printer by printing "Network setup page" out
(please refer to Chapter 9.4
viewing the control panel of printer (please refer to
methods). If the IP address is not listed, please check network environment and
then try again after waiting for several minutes.
Note： • If DHCP server fails to assign IP address automatically, the printer
will get the link-local address assigned by printer automatically: 169.254.xxx.xxx.

4.1.2.Manual Setting

To set up IP address for printer through the control panel of printer manually,
please refer to Chapter 9.2
To set up IP address for printer through the embedded Web server manually,
please refer to Chapter 6.2.1
for printing method) or check network information by
for details.
for details.
Chapter 9.3 for viewing
28