Remote Controller Installation - Navien NR-180 Installation Manual

Navien Gas Water Heater Installation

█ Remote Controller Installation:

Remote Controller NR-10DU
The following are considerations for determining the location of the
remote controller:
 Disconnect the power to the water heater before installing the remote
controller.
 The wire on the reserve of a remote controller is connected to the orange
wire on the PCB board which is located on bottom of the Water Heater.
The naked wire must be completely insulated after connection. DO NOT
connect 110~120VAC to this remote controller.
 The maximum length of wire between the Water Heater and the remote
controller installation location is limited to a maximum of 300 feet.
 There is no polarity.
 The remote controller is water resistant but not water proof.
 Do not install the remote controller outdoors.
 Do not install the remote controller in any area where the control will be
directly exposed to water, heat, humidity or steam.
 Place remote controller out of children's reach.
 Do not disassemble the remote controller.
 Feed the remote controller wire through the black rubber seal at the
bottom, right hand, back corner of the case through.
37