Exifu Card And Connections For Pcpro - NEC XN120 Getting Started Manual

EXIFU Card & Connections for PCPro

EXIFU card and Connections for PCPro

There are two methods of connecting your PC directly to the XN120 system in order to use
PCPro.
Ethernet Connection
You will need the EXIFU-A card installed in the XN120.
Connect the Ethernet socket of the EXIFU-A card to a NIC card on your PC. This can be
either via LAN or directly via a LAN cross cable.
You will need to setup the NIC in your PC before you can communicate with the XN120.
Serial Connection
You will need either the EXIFU-A or EXIFU-B card installed in the XN120.
Connect the serial (RS232 9-pin) socket of the EXIFU card to a serial COM port on you PC.
You will need to setup the COM port in your PC before you can communicate with the XN120.
There are also two methods of connecting via a dial in call on one of the trunks of the XN120
(remote access).
ISDN DDI to 830
You will need a DDI number routed to a special code in Program 22-11-02. The special code
is 830, a data call to the DDI number will be able to connect to the PC Programming interface
of the XN120. You do not need an EXIFU card installed in the XN120.
You will need an ISDN terminal adapter connected to your PC in order to initiate the data call.
ISDN or Analogue trunk to a modem
You will need either the EXIFU-A or EXIFU-B card installed in the XN120.
Connect the serial (RS232 9-pin) socket of the EXIFU card to a modem. The modem is
accessed either by routing a trunk/DDI directly to it or by a transferred call from any user on
the XN120.
You will need to setup the serial port of the EXIFU card before it can be used for PCPro via a
modem. (A PC running a terminal application and connected via a serial cross cable is
required to setup the EXIFU card.)
You will need a modem connected to your PC in order to initiate the call.
BRIU Card
With DDI to
830 setup
6
ISDN BRI
ISDN
ISDN
Terminal
Adapter