Connections; Step1: Placing Speakers And Subwoofer; Step2: Connecting Speakers And Subwoofer - Philips MCD129/93 User Manual

Connections

Step 1: Placing speakers and
subwoofer
For best possible surround sound, locate your
speakers and subwoofer as follows:
●
Place the left and right speakers at equal
distances from the TV set and at an angle of
approximately 45 degrees from the listening
position.
●
Place the subwoofer on the floor near the TV
set.
Notes:
– To avoid magnetic interference, do not position
the left and right speakers too close to your TV set.
– Allow adequate ventilation around the DVD
System.
IMPORTANT!
The type plate is located on the bottom
of the system.
To avoid overheating of the system, a
safety circuit has been built in. Therefore,
your system may switch to Standby
mode automatically under extreme
conditions. If this happens, let the system
cool down before reusing it.
6
Step 2: Connecting speakers
and subwoofer
●
Connect the supplied DIN cable to DVD player's
DIN jack and the left speaker's DIN jack.
●
Connect the supplied speaker wires of the right
speaker to SPEAKER RIGHT on the left speaker,
red wire to red jack ( "+" ), black wire to black
jack ( "-" ). Fully inser t the stripped portion of
the speaker wire into the terminal as shown.
●
Connect the supplied speaker wire of the
subwoofer to SUBWOOFER OUT on the left
speaker, green wire to green jack ( "+" ), white
wire to white jack ( "-" ).
●
Connect the supplied AC power cord to AC
MAINS of the left speaker and the wall socket.
Notes:
– For optimal sound performance, use the
supplied speakers.
– Do not connect more than one speaker to any
one pair of +/- speaker terminals.
– Do not connect speakers with an impedance
lower than the speakers supplied. Please refer to
the SPECIFICATIONS section of this manual.
ANTENNA
FM
(75Ω)