Ad905W Wireless System; (Only For Lx3750W) - Philips LX3700D Owner's Manual

AD905W Wireless System

(Only for LX3750W)

The AD905W accessory gives you the option for wireless
speaker connection.
Please check you have all the supplied parts for your
AD905W wireless set:
– 1 x AD905WT
WIRELESS TRANSMITTER
– 1 x AD905WA
WIRELESS RECEIVER
– 1 x 14V adapter
– 1 x table stand
1 Remove the PHILIPS cover from the AD905WA
as shown in Fig. 1, to access the connection
RECEIVER
terminal. Connect your rear speaker terminals with the
corresponding color terminals on the AD905WA
WIRELESS RECEIVER
2 Insert the table stand into the brackets as shown in Fig.2.
3 Connect the AD905WA
to your power supply.
4 Check / adjust the AD905WA
ON switch to the ON position (see Fig.1).
The AD905WA
WIRELESS RECEIVER
lights up green.
5 Connect the 14V power adapter to the AD905WT
and power supply as shown in Fig.
WIRELESS TRANSMITTER
3.
6 Make sure you position both the AD905WT
and AD905WA
TRANSMITTER
2 meters apart.
7 Connect and carefully match the AD905WT
inputs to the corresponding surround
TRANSMITTER
speaker jacks on your LX3750W DVD system.
The AD905WT
WIRELESS TRANSMITTER
indicator lights up red.
8 Check and adjust the 4-channel toggle switch on the
AD905WT
WIRELESS TRANSMITTER
(CHANNEL SELECTOR switch),
WIRELESS RECEIVER
so that both units are using the same channel.
9 On your LX3750W DVD system, play an audio source
and activate the surround sound mode option. Adjust the
volume to reproduce surround sound in the rear speakers.
10 Extend the antenna vertically on both the AD905WT
and AD905WA
WIRELESS TRANSMITTER
to improve reception. Check the antennas are
RECEIVER
safely positioned without obstruction.
To ensure quality sound production and
transmission
WIRELESS
power cord
WIRELESS RECEIVER
OFF-
WIRELESS RECEIVER
power indicator
WIRELESS
at least
WIRELESS RECEIVER
WIRELESS
power
and AD905WA
WIRELESS
Place both the AD905WT
WIRELESS TRANSMITTER
AD905WA
WIRELESS RECEIVER
(recommended minimum height of 30cm).
Avoid placing the AD905WT
close to your DVD receiver, AC power adapter, TV or other
electrical equipment as it may cause electrical interference.
In case of sound distortion, please select another channel
for both the AD905WA
WIRELESS RECEIVER
AD905WT
WIRELESS TRANSMITTER
be the result of interference caused by other equipment
using same frequency channel in your house or
neighbourhood.
Notes
After you switch off your DVD system, the AD905WT
–
automatically enters standby mode and
WIRELESS TRANSMITTER
the red power indicator eventually comes out. On receiving an
incoming audio signal from your DVD system again, the
AD905WT
WIRELESS TRANSMITTER
– When the AD905WA
WIRELESS RECEIVER
power standby mode, the power indicator lights up red.
1
3
Connections
and
off the ground
too
WIRELESS TRANSMITTER
and
. The distortion could
automatically powers up.
enters the Eco-
2
1
4
C 13
ONNECTIONS