Troubleshooting - Philips LX3700D Owner's Manual

Troubleshooting

WARNING!
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not
open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to solve
a problem by following these hints, consult your dealer or service center.
Problem
No power.
No picture.
Distorted or poor picture.
The aspect ratio of the screen
cannot be changed even though
you have set the TV shape.
No sound or distorted sound.
No sound is heard from the
center or rear speakers.
The DVD player does not
start playback.
The DVD system does not respond
when the buttons are pressed.
The language for the sound or
subtitle cannot be changed when
playing a DVD.
No image is output when a
function is selected.
Considerable noise in radio
broadcasts.
The remote control does not
function.
The display is dark.
Low hum or buzz sound.
Low bass response.
T
30
ROUBLESHOOTING
Solution
– Check if the AC power cord is properly connected.
– Select the appropriate video input mode on the TV.
– Check if the TV is switched on.
– Check the video connection.
– Check the system is securely connected.
– Sometimes a small amount of picture distortion may appear. This is not a malfunction.
– Clean the disc.
– Connect the system to TV's S-video input.
– The aspect ratio is fixed on the DVD disc.
– Depending on the TV, it may not allow to change the aspect ratio.
– Adjust the volume.
– Check that the speakers are connected correctly.
– Replace the speaker cables.
– Check the speaker settings.
– The system is in pause, slow motion or fast forward/reverse mode, press PLAY to resume
normal play mode.
– Use the CENTER +/- or REAR+/- to adjust the volume level.
– Check that the center or rear surround speakers is connected correctly.
– Use surround mode.
– Insert a readable disc.
– Check the disc type, color system and region code.
– Clean the disc.
– Place the disc with the playback side down.
– Press SYSTEM MENU to turn off the setup menu screen.
– Cancel the parental control rating function or change the rating level.
– Moisture has condensed inside the system. Remove the disc and leave the system turned on
for about an hour.
– Disconnect the power plug from the outlet, and insert again.
– Multi-language sound or subtitle is not recorded on the DVD.
– Changing the language for the sound or subtitle is prohibited on the DVD.
– Make sure the component is connected correctly.
– Press the correct function button for the input source.
– Tune in the correct frequency.
– Connect the antenna.
– Route RF (AC-3) and digital cables away from the antenna terminals and wires.
– Fully extend the FM wire antenna. Position for best reception and secure to a wall.
– Connect an outdoor FM antenna.
– Adjust the direction and position for best reception.
– Connect an additional or external MW antenna.
– Turn off the equipment causing the noise or move it away from the DVD system.
– Place the antenna farther away from the equipment causing the noise.
– Point the remote control at the remote sensor of the unit.
– Reduce the distance to the player.
– Remove any possible obstacles.
– Replace the batteries with new ones.
– Check that the batteries are loaded correctly.
– Press DIM again.
– Place the DVD system as far away as possible from electric devices with interference.
– Check all speakers for correct polarity.