Light Emitting Diodes (Led) On Battery - Stihl MSA 160 C Instruction Manual

AL 100 charger
This charger waits for the battery to cool
down before starting the charging
process. The battery is cooled normally
by heat transfer to the ambient air.
End of charge
The charger switches itself off
automatically when the battery is fully
charged:
Light emitting diodes on the battery
–
go off
The light emitting diode on the
–
charger goes off
The charger's fan is switched off (if
–
charger is so equipped)
Remove the charged battery from the
charger.
MSA 160 C
Light Emitting Diodes (LED)
on Battery
Four LEDs indicate the charge state of
the battery as well as any problems that
occur with the battery or the machine.
1
Press button (1) to activate the
N
display – display switches off
automatically after 5 seconds
The LEDs can be green, red or flashing.
LED is continuously green.
LED flashes green.
LED is continuously red.
LED flashes red.
During charging
The LEDs indicate the progress of
charging by lighting up continuously or
flashing.
During charging, the current charging
capacity is indicated by a flashing green
LED.
0 - 20 %
20 - 40 %
40 - 60 %
60 - 80 %
80 - 100 %
When the charging process is
completed, the LEDs on the battery
switch off automatically.
If the LEDs on the battery are
continuously red or flash red – see "If the
red LEDs are continuously red / flash".
English
71