Table of Contents
Advertisement
3
Award BIOS Setup Utility
KB Power On Password
Move the cursor to this field and press <Enter>. Enter your pass-
word. You can enter up to 5 characters. Type in exactly the same
password to confirm, then press <Enter>.
The power button will not function once a keyboard password
has been set in this field. You must type the correct password to
power-on the system. If you forgot the password, power-off the
system and remove the battery. Wait for a few seconds and in-
stall it back before powering-on the system.
Hot Key Power On
This field is used to select a function key that you would like to
use to power-on the system.
Onboard FDC Controller
Enabled Enables the onboard floppy disk controller.
Disabled Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Disabled Disables the onboard serial port 1 and/or serial port
Onboard Parallel Port
378/IRQ7, 3BC/IRQ7, 278/IRQ5
Disabled Disables the onboard parallel port.
Parallel Port Mode
The options are SPP, EPP, ECP and ECP+EPP. These apply to a
standard specification and will depend on the type and speed of
your device. Refer to your peripheral's manual for the best op-
tion.
62
The system will automatically select an I/O address
for the onboard serial port 1 and serial port 2.
ally select an I/O address for the onboard serial port
1 and serial port 2.
2.
IRQ for the onboard parallel port.
Allows you to manu-
Selects the I/O address and
Advertisement
Table of Contents
