Table of Contents
Advertisement
2
Hardware Installation
•
Mic-in Jack (Pink - CN11)
This jack is used to connect an external microphone. Use the
C-Media application software to select between using this jack
and the front audio's mic-in jack.
Front Audio
The front audio connector (J11) allows you to connect to the
line-out and mic-in jacks that are at the front panel of your sys-
tem. Using this connector will disable the rear audio's line-out
and mic-in functions.
Remove the jumper caps from pins 5-6 and pins 9-10 of J11
prior to connecting the front audio cable connector. Make sure
pin 1 of the cable connector is aligned with pin 1 of J11. If you
are not using this connector, make sure to replace the jumper
caps back to their original pin locations.
Driver Installation
Install the "Audio Drivers". Refer to chapter 4 for more informa-
tion.
34
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Advertisement
Table of Contents
