Checking The Serverboard Setup - Supero 2022TG-H6IBQRF User Manual

A+ SERVER 2022TG-H6IBQRF/H6RF USER'S MANUAL
2-6

Checking the Serverboard Setup

After you install the 2022TG-H6IBQRF/H6RF in the rack, you will need to open
the unit to make sure the serverboard is properly installed and all the connections
have been made.
Accessing the inside of the System
Before operating the server for the first time, it is important to remove the protective
film covering the top of the chassis, in order to allow for proper ventilation and
cooling.
Removing the Chassis Cover and Protective Film (Figure 2-5)
1. Unplug the AC power cord from any external power source.
2. Remove the two screws which secure the top cover onto the chassis as
shown above.
3. Lift the top cover up and off the chassis.
4. Peel off the protective film covering the top cover and the top of the chassis
5. Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
6. Replace the chassis cover and reconnect the AC power cord.
Figure 2-5. Accessing the Inside of the System
1
3
Caution: Except for short periods of time, do NOT operate the server without the
cover in place. The chassis cover must be in place to allow proper airflow and
prevent overheating
1
1
Remove Two
Screws
2-8
1
2
1
4
Check Ventilation
Openings