Upgrading And Provisioning; Upgrading Firmware; Upgrading Via Web Gui; Upgrading Slave Access Points - Grandstream Networks GWN7600 User Manual

UPGRADING AND PROVISIONING

Upgrading Firmware

The GWN7600 can be upgraded to a new firmware version remotely or locally. This section describes how
to upgrade your GWN7600.

Upgrading via WEB GUI

The GWN7600 can be upgraded via TFTP/HTTP/HTTPS by configuring the URL/IP Address for the
TFTP/HTTP/HTTPS server and selecting a download method. Configure a valid URL for TFTP, HTTP or
HTTPS; the server name can be FQDN or IP address.
Examples of valid URLs:
firmware.grandstream.com/BETA
192.168.5.87
The upgrading configuration can be accessed via Web GUI->System Settings->Maintenance.
Upgrade Via
Firmware Server
Check Update on Boot
Automatic Upgrade check
interval(m)
Upgrade Now

Upgrading Slave Access Points

When the GWN7600 is being paired as slave using another GWN7600 Access Point acting as Controller,
users can upgrade their paired access points from the GWN7600 Master Controller.

Table 8: Network Upgrade Configuration

Allow users to choose the firmware upgrade method: TFTP, HTTP
or HTTPS.
Define the server path for the firmware server.
Allows the device to check if there is a firmware from the configured
firmware server at boot.
Set the value for automatic upgrade check in minutes.
Click on
device will reboot after downloading the firmware.
GWN7600 User Manual
button to begin the upgrade. Note that the
P a g e | 38