Oki C612 User Manual page 34

ITEM
Network Network Scale
Setup (cont.)
Gigabit Network
Hub Link Setting
Network Factory
Defaults
USB Setup USB
Speed
Soft Reset
Serial Number
Offline Receive
USB Memory Interface
Connected Host
Print Setup Personality
Copies
Duplex
Binding
Media Check
SETTINGS EXPLANATION
Normal When Normal is selected, the network can work
effectively even when it is connected to a HUB that
Small
has a spanning tree feature. However, printer start
up time gets longer when computers are
connected with two or three small LANs.
When Small is selected, computers can cover
from two or three small LANs to a large LAN, but
may not work effectively when the network is
connected to a HUB with a spanning tree feature.
Enable Sets whether to support a gigabit network.
Disable When it is disabled, 1000Base-T Full/Half
duplex connection cannot be made.
Auto Negotiate Sets a method to link to a HUB. When Auto is
set, a connection method to a HUB is selected
100Base-TX Full
automatically and attempts to connect.
100Base-TX Half
If another method is selected, attempts to connect
10Base-T Full
to a HUB only by the selected connection method.
10Base-T Half
Execute Specifies whether to initialize the network
factory default settings for the Network.
Enable / Disable Enables / Disables the USB port.
480 / 12 Mbps Selects the interface speed. After setting
change the menu, the printer restarts on exit.
Enable / Disable Enables or disables the Soft Reset command.
Enable / Disable Specifies whether to Enable or Disable a
USB serial number.
The USB serial number is used to identify the
USB device connected to your PC.
Enable / Disable Offline receive.
Enable / Disable Sets able/disable of USB memory I/F.
Normal If the printer is connected to a specific host
by USB, set it to Specific to print from this
Specific
specific host.
Auto Selects a printer language.
PostScript
PCL
XPS
IBM PPR
EPSON FX
1- 999 Selects the number of copies.
This setting is disabled for Local Print except
for Demo Page.
On/Off Specifies duplex print (option) if a duplex
unit is installed and enabled
Long Edge Specifies Binding in duplex printing.
Short Edge Display Conditions: A duplex unit is installed
and enabled.
Refer to
Enable Sets whether the printer checks the matching
of printed data size and that of the tray. Only
Disable
standard sizes are checked.
Menu functions > 34
"Duplex" on page 34.