D-Link DSL-200 Quick Installation Manual page 5

Usb

Hide thumbs Also See for DSL-200:

6) In the Communication Settings window you must provide the PVC settings,

Encapsulation method and Modulation method for configuring the Modem.

Type in the VPI and VCI values in their respective fields.

7) In the same window, select the appropriate Encapsulation method from the

drop-down menu. You will select the encapsulation setting that is appropriate for

the driver you are installing.

For RFC 2516 PPPoE, select RFC 2516 PPPoE Encapsulation. If you using

RFC 2364 PPPoATM and your service provider have not specified an

encapsulation setting, use RFC 2364 PPPoATM NULL Encapsulation.

If you are using the LAN driver, select the appropriate RFC 1483 encapsulation

setting. If your service provider has not specified an encapsulation setting, use

RFC 1483 IPoATM Bridged LLC Encapsulation.

8) Again in the same window, select the proper Modulation settings using the drop-

down menu. Your service provider will give you the appropriate Modulation

settings. Choose T1.413, Multimode, G.Lite or G.DMT. If your service provider

has not specified a modulation setting, use Multimode. Click Next to continue.

At this point you must choose the Encapsulation method and

Modulation technique used for your ADSL connection. Be sure to

have the correct information available.

Enter your

VPI

and VCI.

Select your

Encapsulation.

Select your Modulation.

Click

Table of Contents