Kenwood KDC-U556BT Service Manual page 15

4.2.6.3 Status display during adjustment
Status
Adjustment success
Adjustment failure
4.2.6.4 Operation of return to TUNER Test Mode
Operation
RETURN Mode release
4.2.6.5 BAND switch list
Type BAND1
K (1)FM1
M (1)FM1
4.2.7 USB Test Mode Specification
Status display during iPod IC check.
Status
Information display iPod verification
IC mount status display
4.2.8 Sirius XM Test Mode Specification
Upon entering production mode, change to SXM source to enter Sirius XM test mode.
This test mode is to check output and switching of SXV100's internal tone generator
Communication between Host & SXV100 will be checked.
If the result is OK, a 1kHz signal from the internal tone generator of SXV100 will be outputted.
This test mode will start from Channel 0 automatically.
Operation
Left & Right Channel
RETURN
Left Channel
(Toggle)
Right Channel
Off
When the unit receives channel other "Channel 0", normal display rule should apply.
4.2.9 CD Test Mode Specification
It shall be the same as normal RST start in other than the below setting.
Playback track from top
Default for Display mode
Display content
A D J O K
A D J N G
Display content
BAND2 BAND3
FM2 FM3
FM2 FM3
Display content
i P o d
i P o d
Display content
# # # # # # #
L E F T
R I G H T
O F F
Content
(No.WA049<Rev.001>)15/26
When the adjustment value write-in to E2PROM
(IC771 on X34) has been completed.
xx: Level offset value (HEX)
: x x
P-CON is turned Off at the same time when this
adjustment succeed.
Upon exit, P-CON still remain OFF.
When the adjustment value write-in to E2PROM
(IC771 on X34) has failed.
P-CON remain turn On at the same time when this
adjustment fail.
Upon exit, P-CON still remain ON.
Return to TUNER Test Mode
BAND4 BAND5
(2)AM -
(2)MW (3)SW1
iPod verification IC mount status display
Blank: Verifying
NG: Verification IC not mounted
Upon source change to USB source or USB
device plug in:
:
In the case of verifying: show iPod : Blank.
: N G
In the case of NG: always show iPod :NG even
during No Device or playback.
In the case of OK: change back to normal dis-
play (No device, normal playback display).
########: 8 characters Radio ID.
Output 1kHz signal for Left/ Right channel.(Default)
#
Output 1kHz signal for Left channel.
Output 1kHz signal for Right channel.
No signal output (same as normal operation).
No.9
Play time
Details
Details
BAND6 Details
- (1)→(2)→(1)...
(4)SW2 (1)→(2)→(3)→(4)→(1)...
Details
Details
Details