Philips DVD962SA Owner's Manual page 13

Stereo has 2-channel analog (right and left Audio In jacks)
1
Connect one of the yellow CVBS VIDEO OUT jacks of the DVD
Player to the corresponding VIDEO IN jack on your TV. Or, use the
S-VIDEO or Pr/Cr Pb/Cb Y VIDEO OUT jacks. Details are on pages 10 and
11. You only need one video connection.
2
Connect the supplied red and white audio cables to the red and
white Left and Right AUDIO OUT jacks on the DVD Player.
Connect the other end of the cables to the left/right AUDIO IN
jacks on the Stereo Receiver. Match the cable colors to the jack colors.
3
Connect the DVD Player's power cord to the MAINS jack on the
rear of the DVD Player. Connect the power cords of the DVD
Player and the TV to the power outlet. Turn on the power of the
TV and the DVD Player.
4
Set the TV to the correct Video In channel. This channel may be near
channel 00. See your TV owner's manual for details. Or, continue to
change channels at the TV until you see the DVD Player's screen saver on
the TV screen.
5
Set your Stereo Receiver to the correct Audio In channel or sound
source. Refer to the owner's manual of the Stereo Receiver.
Connecting to a TV and a Stereo Receiver
Stereo has Dolby Surround or
Stereo
(example only)
LEFT AUDIO IN
3
RIGHT AUDIO IN
SURROUND
DIGITAL AUDIO OUT
PCM/MPEG2/Dolby Digital/DTS
L
R
MAINS
SURROUND
COAXIAL OPTICAL
MULTICHANNEL AUDIO OUT
Back of TV
2 (example only)
VIDEO IN
CENTER FRONT
L 1
R 2
SUB WF FRONT AUDIO P /C P /C
CVBS r r b b Y S-VIDEO
OUT VIDEO OUT
Hookups (cont'd) 13
CVBS
1
PROGRESSIVE SCAN OUT
P /C P /C Y
r r b b