Voltage Inspection; Battery Testing - Honda CBR125R Owner's Manual

BATTERY
REMOVAL/INSTALLATION
Remove the single seat (page 2-4).
Turn the ignition switch OFF.
Remove the trim clip and open the battery case
cover.
Disconnect the negative (–) cable first and then the
positive (+) cable.
Remove the battery.
Install the battery in the reverse order of removal.
Connect the
positive cable first
and then the
negative cable.

VOLTAGE INSPECTION

Measure the battery voltage using a commercially
available digital multimeter.
VOLTAGE (20°C/68°F):
Fully charged:
Under charged: Below 12.4 V
If the battery voltage is below 12.4 V, charge the bat-
tery.

BATTERY TESTING

Refer to the instructions that are appropriate to the
battery testing equipment available to you.
TOOL:
Battery tester
13.0 – 13.2 V
BM-210 or
BATTERY MATE or
equivalent
BATTERY/CHARGING SYSTEM
COVER
NEGATIVE (–) CABLE
POSITIVE (+)
TERMINAL
CLIP
BATTERY
POSITIVE (+) CABLE
NEGATIVE (–)
TERMINAL
16-5