Cisco CVR100W Quick Start Manual page 5

Power off all equipment, including the cable or DSL modem, the PC
S 1
TEP
that you will use to connect to the CVR100W, and the CVR100W.
Connect the supplied power adapter to the 12VDC jack on the
S 2
TEP
back panel. Plug the other end of the power adapter into an
electrical outlet. Make sure that the POWER button is turned off.
Use only the power adapter that is supplied with the unit.
C
AUTION
Using a different power adapter could damage the unit.
Connect one end of an Ethernet cable to your cable or DSL
S 3
TEP
modem. Connect the other end to the WAN port on the back panel.
Connect one end of a different Ethernet cable to one of the LAN
S 4
TEP
ports on the back panel. Connect the other end to an Ethernet port
on the PC that you will use to run web-based Configuration Utility.
Skip this step if you want to connect the PC to the CVR100W
N
OTE
through a wireless connection.
Power on all connected devices including the cable or DSL
S 5
TEP
modem and the PC and wait until the connections are active.
Press the POWER button on the back panel to power on the unit.
S 6
TEP
To connect the PC to your wireless network for the first time, you
S 7
TEP
can configure the wireless connection using the default SSID name
and pre-shared key that are provided on the product label.
A sample configuration is illustrated here.
Internet
Access
Device
Cisco CVR100W Wireless-N VPN Router Quick Start Guide
Local
Network Power
Devices Supply
Wireless
Devices
5