Ls-120 Drive Rear Panel Connectors And Jumpers - IBM Aptiva 2170 Hardware Maintenance Service Manual

LS-120 Drive Rear Panel Connectors and Jumpers

NOTE: Set the jumpers located on your LS-120 drive according to your system
configuration. If you have two drives on a single IDE cable, make sure
you set one of them as Master and the other as Slave.
LS-120 Drive Jumper Settings
Abbreviation
MA
SL
CS
MDO
174
Jumper Name
Master
Slave
Cable Select
Factory Setting
Function
Configures the LS-120 drive as
the Master drive on the secondary
IDE channel.
Configures the LS-120 drive as
the Slave drive on either the
primary or secondary IDE
channel.
This setting is only for computers
that use cable-select cable.
For factory use ONLY. Do not use
this setting.