Operations - Bissell 33N8 SERIES User Manual

Using the Automatic Cleaning Cycles
Tips Before Using Your SpotBot®
• Dry vacuum the area first, before spot cleaning with the SpotBot®.
• Some spots and spills require that you pick up the chunky debris with a rag
or towel before you begin cleaning in the automatic or manual cycles.
1
Quick Clean This cycle has been designed
for stains that are on the surface of your
carpeting. This cycle will run for approxi-
mately 3 minutes.
3
Hose/Tool By selecting this option you
can clean spots and stains using the hose
and tool on surfaces such as upholstery,
stairs, car interiors or any other hard to
reach area.
5
Done This light will illuminate and you will
hear a series of "beeps" when the cleaning
cycle is complete. Press the STOP button
to turn the machine off. The machine will
not beep when turned off.
8
www.BISSELL.com
2
Deep Clean Use on stains that have had
time to set-in. These are typically the most
difficult stain types to remove. This cycle
runs for approximately 6 minutes.
4
Stop By pressing the red stop button, you
will stop the cleaning cycle completely. To
begin cleaning again, you will need to start
over and select a cleaning cycle.
WARNING
Keep spray away from face. Failure to do
so may result in personal injury.