Table of Contents
Advertisement
NETGEAR CG814WH Wireless Cable Modem Gateway
Chapter 2: Using the NETGEAR CG814WH
All interface and status LEDs are provided on the front panel. The power
connectors, signal connectors, and Restore Factory Defaults/Reboot button
are on the rear panel.
The Restore factory settings Button
Briefly pressing the Reset Button will clear all of the Gateway's data and
restore the factory defaults. This should be done only if you are experiencing
heavy routing problems, and only after you have exhausted all of the other
troubleshooting options. By resetting the Gateway, you run the risk of creating
conflicts between your PCs' actual IP Addresses and what the Gateway thinks
their IP Addresses should be. You may be forced to reboot the entire
system(s).
If your Gateway locks up, simply power it down for 5 seconds by removing the
power cable from the Gateway's Power Port. Leaving the power off for too
long could result in the loss of network connections.
5
Advertisement
Table of Contents
