Shindaiwa B450 Owner's And Operator's Manual page 8

Assembly and Adjustments
Handlebar
Throttle Assembly
Outer Tube
Figure 7
1. Remove the 4mm retaining screw
and lower cap from the handlebar
bracket. See Figure 7.
Throttle Cable
Powerhead
Throttle
Cable
Cable Holder
Figure 8
1. Route the powerhead throttle cable
through the cable holder. See Figure 8.
8
Handlebar
Bracket
Installation Decal
Lower Cap Retaining Screws
2. Mount the handlebar on the outer tube
and align it with the "Attach Handle
On This Line" decal.
B45007
Male Stop Switch
Connectors
2. Install the throttle cable sleeve on the
powerhead throttle cable. See Figure 8.
Throttle Cable
Cap
Throttle Cable
Sleeve
B45006
Handlebar
3. Reinstall the lower cap and retaining
bolts. Tighten the retaining screws
evenly.
Female Stop Switch
Connectors
3. Connect the stop switch wire connectors
(two wires). See Figure 8.