Table of Contents
Advertisement
Available languages
Available languages
DANGER
When the "excess gas flow control"
feature is activated,
a small amount of gas is still flowing
to the burners. After
turning
OFF the cylinder
and burner control
knobs, wait at
least 5 minutes for the gas to clear before attempting
to light
the barbecue.
Failure to do so may result in an explosive
flame=up, which can cause serious
bodily injury or death.
3)
Turn the cylinder on by turning the cylinder valve counterclockwise.
4)
Insert match holder with lit match into the matchlight
hole in the front of the
cooking box.
z_ WARNING: Do not lean over open barbecue.
Keep your face
and body at least one foot away from the matchlight
hole
when lighting
the barbecue.
5)
Push BURNER 1 control knob down and turn to START/HI.
6)
Check that the burner is lit by looking through the matchlight
hole on the front of
the cooking
box.You should see a flame.
WARNING: If the burner does not light in five seconds,
turn
the Burner 1 control
knob to OFF and wait 5 minutes to let
the gas clear before you try again.
7)
After BURNER
1 is lit you can turn on BURNER 2 (and BURNER 3).
Note -A/ways
fight BURNER 1 first.The other bumers ignite from BURNER
1.
TO EXTiNGUiSH
Push down and turn each burner control knob clockwise
to the OFF position. Turn gas
supply OFF at the source.
MAIN BURNER MANUAL LIGHTING
*The grill illustrated
may have
slight differences
than the
model purchased.
LIGHTING THE SIDE BURNER
DANGER
Failure to open the lid while igniting the side burner, or not
waiting 5 minutes to allow the gas to clear if the side burner
does not light, may result in an explosive
flame=up which can
cause serious
bodily injury or death.
WARNING:
Check hose before each use of barbecue
for
nicks, cracking,
abrasions
or cuts. If the hose is found to
be damaged
in any way, do not use the barbecue.
Replace
using only Weber ® authorized
replacement
hose. Contact
the Customer
Service Representative
in your area using the
contact
information
on our web site. Log onto www.weber.
com
e .
1)
Open the side burner lid.
2)
Check that the side burner valve is turned off (Push control knob in and turn
clockwise
to ensure that it is in the "OFF" position), turn all burners not being
used to the "OFF" position
(push in and turn clockwise).
WARNING:The
burner control
knobs must be in the OFF
position
before turning
on the liquid propane cylinder
valve. If they are not in the OFF position,
when you turn on
the LP cylinder
valve, the "excess gas flow control"
feature
will activate,
limiting the flow of gas from the LP cylinder.
If this should
occur, turn OFF the LP tank valve and burner
control knobs. Start over.
DANGER
When the "excess gas flow control" feature is activated,
a small amount of gas is still flowing
to the burners. After
turning
OFF the cylinder
and burner control
knobs, wait at
least 5 minutes for the gas to clear before attempting
to light
the barbecue.
Failure to do so may result in an explosive
flame-up,
which can cause serious
bodily injury or death.
3)
Turn the gas supply valve on.
Advertisement
Table of Contents
