Table of Contents
Advertisement
Setting mode <Collective setting>
■ Set the same operation contents to the same program number of all the days of the week. In Step 2 above, select "all of the days of the
week". When the contents that were individually set exist in the same program number, the contents are overwritten.
NOTE
• If no operation is performed for 60 seconds in setting mode, the setting changes that have been made until then become invalid and
the setting mode terminates. Subsequently,
(This blinking can not be observed if setting mode gets terminated while setting only one program.)
• At the end of the setting mode, point the remote control at the air-conditioner and press the PROGRAM button. In this case, check
that the air-conditioner emits a reception buzzer sound three times (pi, pi, pi). If the buzzer sound is not emitted, set the mode to the
setting mode again by pressing the PROGRAM button and check that the buzzer sound is emitted.
7
Press the " or
Set a time.
Every time the
button is pressed, the display is switched in the
order of:
0:00
0:10
0:20
Every time the
button is pressed, the display is switched in the
order of:
0:00 23:50 23:40
When ON TIMER is selected, go to Step 8.
When OFF TIMER is selected, go to Step 9.
8
Set required operation contents.
When ON TIMER is selected, operation mode, fan speed, and airflow direction can be
changed and the ECONO, SILENT or NIGHT SETBACK operation can be set.
9
Press the SET button.
The time is determined and
10
Press the PROGRAM
When the PROGRAM button is pressed, the setting is sent to the air-conditioner.
Since it takes 3 seconds for transmission, point the remote control at the remote control
signal receiver of the indoor unit during the period.
When the setting is received, a buzzer sound (pi, pi, pi) is emitted.
When the SET button is pressed, the setting continues from Step 2.
and all the program numbers (P1, P2, P3 and P4) blink for 10 seconds.
– 21 –
(TIMER)" button.
...
1:00
1:10
(Units of ten minutes)
...
(Units of ten minutes)
23:00 22:50
and
blink.
button or SET button.
Hide quick links:
Advertisement
Table of Contents
