HP MSR Series Configuration Manual page 55

Figure 16 Network diagram
Configuration procedure
Configure the IP address of each interface as shown in
1.
2. Configure a track entry on Router A:
# Configure track entry 1, and associate it with the physical status of the uplink interface Ethernet
1/2.
[RouterA] track 1 interface ethernet 1/2
3. Configure VRRP on Router A:
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] vrrp vrid 1 virtual-ip 10.1.1.10
# Set the priority of Router A in VRRP group 1 to 110.
[RouterA-Ethernet1/1] vrrp vrid 1 priority 110
# Configure to monitor track entry 1 and specify the priority decrement as 30.
[RouterA-Ethernet1/1] vrrp vrid 1 track 1 reduced 30
4. Configure VRRP on Router B:
<RouterB> system-view
[RouterB] interface ethernet 1/1
# Create VRRP group 1, and configure the virtual IP address 10.1.1.10 for the group.
[RouterB-Ethernet1/1] vrrp vrid 1 virtual-ip 10.1.1.10
Verifying the configuration
After configuration, ping Host B on Host A, and you can see that Host B is reachable. Use the display
vrrp command to view the configuration result.
# Display detailed information about VRRP group 1 on Router A.
[RouterA-Ethernet1/1] display vrrp verbose
IPv4 Standby Information:
Run Mode
Run Method
Total number of virtual routers : 1
Interface Ethernet1/1
: Standard
: Virtual MAC
51
Figure 16. (Details not shown.)