Volvo XC90 TWIN ENGINE Owner's Manual page 142

INSTRUMENTS AND CONTROLS
||
Position Specification
Daytime running lights when the
car's electrical system is in ignition
position II or when the car is run-
ning.
Main beam flash can be used.
Daytime running lights and position
lamps when the car's electrical sys-
tem is in ignition position II or when
the car is running.
Position lamps when the car is
A
parked .
Main beam flash can be used.
Dipped beam and position lamps.
Main beam can be activated.
Main beam flash can be used.
LED (Light Emitting Diode)
46
140
Position Specification
Daytime running lights and position
lamps in daylight when the car's
electrical system is in ignition posi-
tion II or when the car is running.
Dipped beam and position lamps in
weak daylight or darkness, or when
the front fog lamp* and/or rear fog
lamp are activated.
The Active main beam function can
be activated.
Main beam can be activated when
dipped beam is switched on.
Main beam flash can be used.
Active main beam on/off.
A Also at stationary when the car is running, provided that the
rotating ring is moved to this position from another position.
Volvo recommends that mode is used
when the vehicle is driven.
WARNING
The car's audio system is not able to deter-
mine when daylight is too weak or sufficiently
strong, e.g. in fog and rain, in all situations.
The driver is always responsible for ensuring
that the car is driven with a beam pattern suit-
able for the traffic situation and in accordance
with applicable traffic regulations.
Thumbwheel in the instrument panel
Thumbwheel for adjusting interior brightness
Thumbwheel for headlamp levelling
46
A car with LED headlamps* has automatic
headlamp levelling and therefore does not have
the thumbwheel for headlamp levelling.
* Option/accessory, for more information, see Introduction.