Table of Contents
Advertisement
Figure #19
Instructions for Closing burner Swing Door
1.
Swing burner and door to right until insulation is
slightly compressed and stud is exposed.
2.
Attach nut to the stud and tighten it until the built in
stop contacts the mounting door.
3.
Replace oil line to burner.
4.
Replace lower jacket panel, and tighten screws.
Connect power cable at factory supplied burner
5.
electrical disconnect.
6.
Turn on power to boiler.
7.
Bleed oil line.
OPERATING INSTRUCTIONS
21
Advertisement
Table of Contents
