E-Studio163/203 - Toshiba e-STUDIO163 Service Manual
Multifunctional digital systems
Hide thumbs
Also See for e-STUDIO163:
- Service manual (236 pages) ,
- Service handbook (235 pages) ,
- Operator's manual (162 pages)
Table of Contents
Advertisement
GENERAL PRECAUTIONS REGARDING THE SERVICE FOR
e-STUDIO163/203
The installation and service should be done by a qualified service
technician.
1) Transportation/Installation
-
When transporting/installing the equipment, employ two persons and be sure to hold the posi-
tions as shown in the figure.
The equipment is quite heavy and weighs approximately 30 kg (66.18 lb), therefore pay full atten-
tion when handling it.
-
Be sure not to hold the movable parts or units when transporting the equipment.
-
Be sure to use a dedicated outlet with AC 110 V / 13.2 A, 115 V or 127 V / 12 A, 220-240 V or 240
V / 8 A for its power source.
-
The equipment must be grounded for safety.
-
Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and
direct sunlight.
-
Provide proper ventilation since the equipment emits a slight amount of ozone.
-
To insure adequate working space for the copying operation, keep a minimum clearance of 80
cm (32") on the left, 80 cm (32") on the right and 10 cm (4") on the rear.
-
The equipment shall be installed near the socket outlet and shall be accessible.
-
Be sure to fix and plug in the power cable securely after the installation so that no one trips over
it.
T.B.D.
Advertisement
Table of Contents
