Toshiba e-STUDIO163 Service Handbook page 97

[C] Reproduction ratio adjustment of the secondary scanning direction
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Place a ruler on the original glass with its leading edge pushed against the original scale on the
left.
(3) Make a copy at the mode of A3 (LD), 100% and standard drawer of the equipment.
(4) Measure the distance C from 200 mm to 400 mm of the copied image of the ruler.
(5) Check if the distance C is within the range of 200±0.5 mm.
(6) If not, use the following procedure to change values and repeat steps (1) to (5) above.
(Adjustment Mode)
(Key in a value (acceptable values: 0 to 255))
Press the [ENTER] or the [INTERRUPT] button (stored in memory).
("100% A" is displayed.)
* The smaller the adjustment value is, the lower the reproduction ratio becomes (0.45 mm/
step).
50 100
December 2005 © TOSHIBA TEC
(Key in the code [340])
Copied image of the ruler
150 200
Feeding direction
Fig. 3-11
3 - 13
(Adjustment Mode)
[START]
250 300 350
C
e-STUDIO163/203 ADJUSTMENT
400
3