Uniden GNC 701 Quick Start Manual page 4

GNC701 Installation
Step 1: Use the included inner hex
wrench to unfasten the dome enclosure.
Step 2: Install Micro SD card (optional).
Step 3: Place and stick the installation
position map on the ceiling or the wall to
suit your desired location.
Step 4: Find and drill the small cross
signs on the map to fit three plastic
expansion bolts holes. Insert the
expansion bolts into the holes.
Step 5: Position the dome body to
match the three screw holes. Fasten
the installation screws to secure the
dome body onto the ceiling or wall. Do not let the cable get caught in between the dome body
and the wall.
Step 6: Adjust the lens viewing direction by rotating the LED cover or rotate the dome bracket
or tilt it vertically. Range of adjustment: vertical (0°~64°), horizontal (0°~355°) & image rotation
.
(0°~355°)
Step 7: Put on back the dome enclosure according to the hole and fasten the three inner hex
screws firmly.
4