Progress Of Programme; Changing The Programme After It Has Started - Beko DCU 7230 User Manual

Operating the product

6.12 Progress of programme

Progress of a running programme is shown
through the programme follow-up indicator.
At the beginning of every programme step,
the relevant indicator LED will light up and
light of the completed step will turn off.
"Drying":
- Drying level will be illuminated during the
whole drying process until the drying degree
reaches "iron dry".
"Iron Dry":
- Starts to illuminate when the drying
degree reaches "iron dry" step and remains
illuminated until the next step.
"Cupboard dry":
Starts to illuminate when the drying degree
reaches "Ready to wear" step and remains
illuminated until the next step.
"Final / Anti-creasing":
- Illuminates when the programme comes
to an end and anti-creasing function is
activated.
C
If more than one LED light up or
flash concurrently, it means there
is malfunctioning or a failure
(please see, Solution suggestions
for problems).
6.13 Changing the programme
after it has started
You can use this feature to dry your clothes
under higher or lower temperatures after
your dryer has started.
For example;
1. Press and hold the "Start/Pause/Cancel"
button for about 3 seconds to "Cancel"
the programme in order to select "Extra
Dry" programme instead of "Iron Dry"
programme.
2. Select the "Extra Dry" programme by
rotating the programme selection button.
3. Press "Start/Pause/Cancel" button to
start the programme.
24 / EN
C
Press "Start/Pause/Cancel"
button for 3 seconds to cancel
the programme or turn the
programme selection knob in any
direction to end the programme
while the machine is running.
Water tank and filter cleaning
warning lights turn on to warn
the user when the programme is
cancelled by pressing the "Start/
Pause/Cancel" button for 3
seconds. However, the warning
lights do not turn on when
the programme is cancelled by
turning the programme selection
knob. Only the drying light turns
on and the machine remains in
hold until a new programme is
selected and the "Start/Pause/
Cancel" button is pressed. Child-
proof lock of the machine should
not be active in order to perform
these two operations. If the child-
proof lock is active, deactivate
it before performing these
operations.
Adding/removing laundry in standby
mode
In order to add or remove laundry after the
programme starts:
1. Press the "Start/Pause/Cancel" button to
switch the dryer to "Pause" mode. Drying
process will stop.
2. Open the door at "Pause" position and
close it again after adding or taking out
laundry.
3. Press "Start/Pause/Cancel" button to
start the programme.
C
Any laundry added after the
drying process has started may
cause the dried clothes in the
machine intermingle with wet
clothes and the result will be wet
laundry after the drying process
is over.
Dryer / User Manual