Siemens SIMATIC S7-1500 System Manual page 196

CPU display
②
Regarding : Names of the m enus
The following table shows the available menus of the display.
Table 12- 2
Ma in menu items
196
Names of the menus
Me aning D e scription
Overview The "Overview" menu contains information about the properties
of the CPU and the properties of the inserted SIMATIC memory
card, as well as information on whether a know-how protection or
a linking of the serial number exists.
For F-CPUs, the status of the safety mode, the collective signa-
ture and the date of the last change in the F-CPU is displayed.
Diagnostics The "Diagnostics" menu includes:
•
•
•
•
•
Settings In the "Settings" menu, you can:
•
•
•
•
•
•
•
•
•
•
•
Modules The "Modules" menu contains information about the central and
distributed modules that are used in your configuration.
Peripherally deployed modules are connected to the CPU via
PROFINET and/or PROFIBUS.
You can set the IP addresses for the CPU or a CP/CM here.
Fail-safe parameters are displayed for F-modules.
Display In the "Display" menu you can configure settings related to the
display, such as language setting, brightness and energy-saving
mode. The energy-saving mode dims the display. The standby
mode selectors the display off.
Display of diagnostic messages.
Read/write access to force and watch tables.
Display of cycle time.
Display of CPU memory utilization.
Display of interrupts.
Assign the IP addresses and the PROFINET device name of
the CPU.
Set the network properties of each CPU interface.
Set the date, time, time zones, operating modes (RUN/STOP)
and protection levels.
Disable/enable display with display password.
Perform a CPU memory reset.
Perform a reset to factory settings.
Format the SIMATIC memory card.
Delete the the user program.
Back up/restore the CPU configuration to/from the SIMATIC
memory card.
View the status of the firmware update.
Convert the SIMATIC memory card into a program card
System Manual, 09/2016, A5E03461182-AD
Automation system