Jenn-Air CP240B Repair Manual page 15

Probe
To set: 1_
1. insert probe into probe receptacle located in the front of the
air gri(le. Be certain to insert p(ug into the receptacle all the
way.
2. Touch Probe Select Pad. The Indicator Word Probe will flash and the Indicator
Bar, "---", and ° will appear solid in the Display.
NOTE: If the probe is not inserted into the receptacle, a signal will beep until probe
is inserted, Additiorially, a temperature cannot be set until the probe has been
inserted into the rece'ptacle.
3. Touch the Up or Down Arrow Pad. The beginning temperature shown in the
Display is 100°For the lastvalid setting. By continuouslytouching the Arrow Pad,
the temperature will quickly advance. To slow down the rate of advancement, tap
the Arrow Pads.
(Allowable range is 100° to 500° in 5o increments.)
Three seconds after using the Arrow Pads, the probe temperature will a_tomati-
c_,llybe set, Then, the Display will show probe temperature or 100%whichever
is higher.
NOTE: if more than 10 seconds elapse between touching Probe Select Pad and
touching an Arrow Pad, the Probe Select Pad must be touched again to set the
numbers,
When selectedtemperature has been reached, asignal will beep untiithe function
has been cancelled or the probe removed from the receptacle.
IMPORTANT: The Probe does not shut off the surface controls. Once selected
internal temperature has been reached, remove food immediately to prevent
overcooking.
To recall Probe temperature set: Touch the Probe Recall Pad, The temperature
will be displayed briefly before returning to actual probe temperature.
To cancel:
1. A. The indicator Bar needs to be above the Indicator Word Probe. If it is not,
touch the Probe Select Pad.
B. Touch the Off Pad.
or
2. Remove the probe from the receptacle.
15