Initialize - Yamaha MU100 Service Manual

INITIALIZE

The Initialize functions allow you to restore the factory settings of the
MU100.
NOTE
Since the Initialize functions replace existing data, you should save any and all
important settings to a MIDI data storage device before using these functions.
Operation
1. Press the UTIL button and select "INITIAL," then press the ENTER
button.
2. From the Initialize menu, select the type of data to be initialized:
Factory Settings (FactSet), selected Sound Module mode (XGInit, GM
Init, C/MInit, PFMInit) or Drum (DrumInit) Then, press the ENTER
button to call up the selected data dump.
Factory Settings (FactSet)
This restores the original factory settings of the MU100.
Selected Sound Module Mode:
XG (XGInit)
General MIDI (GM Init)
Computer Music (C/MInit)
Performance (PFMInit)
One of the four parameters above will be available, depending on the
currently selected Sound Module mode: XG, TG300B, C/M or PFM.
Initializing this parameter restores the original settings for the selected mode.
NOTES
For the PFMInit setting, only the currently selected Performance will be initialized.
For XGInit and GM Init, the initialized settings are the same as when the MU100
is reset upon receiving an XG System On or GM System On message.
Drum (DrumInit)
Range: DrumS1 — DrumS4
This restores the original drum settings for the selected Drum Setup S1
— S4. (Use the VALUE
Drum Setup.)
NOTE
This parameter is not available when the MU100 is set to Performance mode.
3. From the "Are you sure?" prompt, press the ENTER button to execute
the operation, or press the EXIT button to cancel it and return to the
previous display.
An "Executing..." message appears in the display during the operation.
When the operation is completed, the MU100 returns to the Initialize
menu.
MU100
buttons or data dial to select the desired
25