Panel Buttons - Tesla 6 SERIES Operating Instruction

ENG
Precautions for Using Battery
Inadequate use of batteries may cause leakage. Therefore, please follow the steps below and
use them with care.
1. Please note the batteries polarity to avoid short circuit.
2. If the battery voltage is insufficient, which affects the remote control range, you should
replace used batteries with the new ones. Remove batteries from the remote control unit if
you do not intend to use it for a long time.
3. Do not use different types of batteries (for example, manganese and alkaline batteries)
together.
4. Do not put the batteries into fire. Do not charge or disassemble batteries.
5. Please dispose of batteries in accordance with the relevant environmental protection
regulations.
Remote Control Battery Replacement
Place two AAA batteries in the remote control battery compartment, making sure that the
polarity markings inside the compartment are matched.
Note: The images are intended for reference only. Actual items may differ.
1
Slide the cover
horizontally.

PANEl BUTTONS

Note: The images are intended for reference only.
Bottom view
Power Indicator /
Remote Sensor
Note: When the input ports has no signal input, the TV will go into standby mode.
2
Speaker
Control buttons
Place two AAA batteries
and make sure that the
polarity is correct.
Press middle button:
1. In standby mode, press it to turn on the TV;
2. Without OSD, short press it to access source
menu;
long press to turn the TV to standby;
3. With OSD, short press it to confirm a
selection; long press it to turn off the TV.
Push left: decrease volume or go to left.
Push right: increase volume or go to right.
Push forward: channel up or go to above
Push backward: channel down or go to
below.
6
Slide horizontally to
3
close the cover.