ALDI V4916DSO364 User Manual page 19

and day of the week as well as current room
temperature in alternation. Additionally, the
display and key lighting of the buttons ( ) ear
measurement and ( ) forehead measurement
illuminate for a few seconds.
If the thermometer is switched off, you
can switch it on by pressing any button.
The thermometer will then switch to
standby mode. In this mode, the time,
date and room temperature will continu-
ally alternate on the display.
To correctly position the display in
standby mode and configuration mode,
make sure that the front side with the
buttons is pointing towards the user. In
temperature measuring mode and in
memory mode, it should be positioned
the other way around: In this case, the
display is correctly positioned by holding
the thermometer so that the back side is
pointing towards the user.
If you would like to immediately switch
back to standby mode from configura-
tion or memory mode, you must push
the buttons ( ) ear measurement and
( ) forehead measurement at the same
time. The thermometer will automati-
cally switch to standby mode if there is
no button activity for approx. 1 minute
after performing the temperature mea-
surement or, in configuration or memory
mode, within approx.
30 seconds.
Setup
19