Saeco HD8766 User Manual page 59

Machine actions
The machine does not turn on.
The drip tray gets fi lled although
no water is drained.
The red icon is always dis-
played on the machine.
Coff ee is not hot enough.
No hot water or steam is dis-
pensed.
Coff ee does not have enough
crema (see note).
The brew group cannot be
removed.
The brew group cannot be
inserted.
There is a lot of ground coff ee
under the brew group.
Causes
The machine is not connected to the
electric network.
The power button is on position "0".
Water is sometimes drained automati-
cally by the machine into the drip tray
to manage the rinsing of the circuits
and ensure optimum machine perfor-
mance.
The coff ee grounds drawer has been
emptied with the machine off .
The temperature is not correctly set.
The cups are cold.
The hole of the steam/hot water wand
is clogged.
The Classic Milk Frother is dirty.
The blend is unsuitable, coff ee is not
freshly roasted or the grind is too
coarse.
The brew group is out of place.
The coff ee grounds drawer is inserted.
The brew group is not in the off
position.
The gearmotor is not in the correct
position.
Coff ee is not suitable for automatic
machines.
ENGLISH
Solutions
Connect the machine to the electric
network.
Check that the power button is set to "I".
This is a normal behavior of the machine.
The coff ee grounds drawer must always
be emptied with the machine on. Wait
until the icon is displayed before refi t-
ting the drawer.
Set the temperature as described in the
"Programming" chapter.
Preheat the cups with hot water.
Clean the hole of the steam wand using
a pin.
Make sure that the machine is off and
has cooled down before performing
this operation.
Clean the Classic Milk Frother.
Change coff ee blend or adjust grinding as
explained in the "Adjusting the Ceramic
Coff ee Grinder" chapter.
Turn on the machine. Close the service
door. The brew group automatically
returns to the initial position.
Remove the coff ee grounds drawer
before removing the brew group.
Make sure that the brew group in
the off position, as described in the
"Weekly Cleaning of the Brew Group"
chapter.
Insert the drip tray and the coff ee
grounds drawer. Close the service door.
Turn on the machine without inserting
the brew group. The gearmotor moves
back to the correct position. Turn off
the machine and reinsert the brew
group as described in the "Weekly
Cleaning of the Brew Group" chapter.
It may be necessary to change the type of
coff ee or the coff ee grinder settings.
57 57