Sealing Parameters; Functions For Switching To Other Zones - Pfaff 8310-041 Instruction Manual

Sealing
10

Sealing parameters

.05.03
●
10

Functions for switching to other zones

.05.04
In addition to the sealing parameters, further functions can be allocated to each zone, which
serve to enable the automatic switch to other zones and a more exact setting of the sealing
operation sequence.
●
Description of the functions
Programmed section
mm
This function is used to determine the length of the current zone. The value in millimetres is
entered on the appropriate number block. When the function is activated, the machine swit-
ches to the next seam zone after processing the entered section.
Programmed stop
When this function is switched on, the current zone takes on a stop function. The sealing
operation stops and the machine moves to the next zone. The sealing parameters entered
for this zone are not taken into account.
Programmed output
When this function is switched on, the current zone takes on an output switch function. Two
outputs can be stipulated with the appropriate menu. The sealing parameters entered for
this zone are not taken into account.
Programmed input
When this function is switched on, the machine does not switch to another zone until an ap-
propriate input signal is given or not given. The two different inputs can be set up with the
appropriate menu.
Sealing on/off
When this function is switched on, the current zone takes on a switch function. The sealing
operation is switched off or on and the machine switches to the next zone. The sealing func-
tion remains switched off/on for the following zones, until the setting is altered again.
40
Sealing parameters for each zone as described in Chapter 9.03 Entering sealing para-
meters.
Select appropriate functions for each zone, activated functions are displayed as inverse
symbols on the screen.